open source flight controller

Pixhawk Combo

$190.00

The Pixhawk is a high-performance autopilot-on-module suitable for fixed wing, multirotors, helicopters, cars, boats and any other robotic platforms. Designed for industry, research and hobbyists alike and combines the functionality of the PX4FMU + PX4IO.

*This is manufactured by a third party and not the 3DR version. We guarantee all parts functioning and firmware upgradable.*

SKU: pixhawk. Category: .
Share Product
The Pixhawk is a high-performance autopilot-on-module suitable for fixed wing, multirotors, helicopters, cars, boats and any other robotic platforms. Designed for industry, research and hobbyists alike and combines the functionality of the PX4FMU + PX4IO.
The flagship Pixhawk module is accompanied by peripherals, including 915MHz Radio telemetry kit, power module, GPS, buzzer,etc.
Pixhawk Autopilot:
  • 168 MHz/252 MIPS Cortex-M4F
  • 14 PWM/Servo outputs (8 with failsafe and manual override, 6 auxiliary, high-power compatible)
  • Abundant connectivity options for additional peripherals(UART, I2C, CAN)
  • Integrated backup system for in-flight recovery and manual override with dedicated processor and stand-alone power supply(fixed-wing use)
  • Backup system integrates mixing, providing consistent autopilot and manual override mixing modes(fixed wing use)
  • Redundant power supply inputs and automatic failover
  • External safety switch
  • Multicolor LED main visual indicator
  • High-power, multi-tone piezo audio indicator
  • MicroSD card for high-rate logging over extended periods of time
915MHz Radio Telemetry:
  • Small size, light weight
  • Receiver sensitivity to -121 dBm
  • Transmit power up to 20dBm (100mW)
  • Transparent serial link
  • Air data rates up to 250kbps
  • Range of approx 1 mile
  • MAVLink protocol framing and status reporting
  • Frequency hopping spread spectrum (FHSS)
  • Adaptive time division multiplexing (TDM)
  • Support for LBT and AFA
  • Configurable duty cycle
  • Built in error correcting code (can correct up to 25% data bit errors)
  • Demonstrated range of several kilometers with a small omni antenna
  • Available to bi-directional amplifier for even more range
  • Open source firmware
  • AT commands for radio configuration
  • RT commands for remote radio configuration
  • Adaptive flow control when used with APM
  • Based on the HopeRF HM-TRP radio module, featuring an SiLabs Si1000 RF micro controller.

Ublox Neo-M8N GPS

  • 167 dBm navigation sensitivity
  • Navigation update rate up to 10 Hz
  • Cold starts: 26s
  • Low noise 3.3V regulator
  • Protective case

Power Module:

  • Deans Plug
  • Max input voltage: 30V
  • Max current sensing: 90A
  • Voltage and current measurement configured for 5V ADC
  • Switching regulator outputs 5.3V and 3A max
  • 6P molex cable plugs directly to APM/Arduflyer 2.5’s ‘PM’ connector

Purchase Includes:

  • 1 x Pixhawk Autopilot
  • 1 x 3DR 915MHzRadio Telemetry Module Air with the case
  • 1 x 3DR 915MHzRadio Telemetry Module Ground with the case
  • 1 x CRIUS MAVLink-OSD Board
  • 1 x Power Module V1.0
  • 1 x Ublox Neo-M8N GPS
  • 1 x GPS Foldable Stand
  • 1 x I2C Splitter Expand Module with 4pin Cable
  • 1 x External LED and USB Module with 6 to 4pin Cable
  • 1 x Glass Fiber Cushioning Seat
  • 1 x Buzzer
  • 1 x Micro USB cable
  • 1 x PPM Encoder with 2 Cables
  • 1 x 4GB MicroSD Card